Commax Dp-ra01 Installation Manual !!hot!! Jun 2026

Note: Wire colors may vary based on the specific cable manufacturer. Always trace wires using a multimeter if colors do not match the standard.

Note: Always double-check the manual included with your specific door camera model. While the colors above are standard for Commax, variations exist in different production years.

Mark the drilling holes, insert wall anchors, and secure the bracket using the provided screws. commax dp-ra01 installation manual

AC 110V / 220V (50/60Hz) depending on your regional model variant.

: Disconnect the power cable if the device will not be used for an extended period. Installation & Mounting Note: Wire colors may vary based on the

Choose an entry position shielded from heavy, direct rainfall or extreme sunlight.

For detailed, model-specific wiring diagrams, it is recommended to view the official Commax Intercom Installation Guide or refer to the specific door station model's installation sheet. While the colors above are standard for Commax,

Strip approximately 5mm of insulation from your signal wires.

Before starting any installation, it is critical to understand the safety guidelines to prevent damage to the equipment or injury: