Voltage selection configurations for 110-220V conversion and motor phase capacitor wiring.

Replace all rubber mushrooms; install a correctly tensioned belt. Flat spot on the idler wheel rubber.

If the motor clamshells are not perfectly realigned during reassembly, the rotor will bind.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

What specific (hum, slow speed, vibrating chassis) are you experiencing?

Happy spinning, — [YourUsername]

Remove the bottom cover plate of the bearing housing (held by three screws). Clean out all old oil using cotton swabs and alcohol.

The TD124 features a massive main bearing housing. Over time, the oil leaks out or becomes contaminated with dust.

The Thorens TD124 is a complex piece of equipment, comprising multiple mechanical and electrical components that work in harmony to produce high-quality sound. Over time, these components can wear out or become damaged, requiring repair or replacement. A service manual provides the necessary instructions, diagrams, and technical specifications to perform these tasks accurately.

The stepped pulley spins on a vertical shaft held by two bronze bushings. Undo the set screw on the top pulley cap and lift it off. Clean the shaft with isopropyl alcohol.

Use a fresh paper or rubber gasket during reassembly to prevent slow oil leaks onto your furniture. 3. Essential Specifications

To get the most out of your Thorens TD124 service manual:

The motor is suspended on rubber grommets, often called "mushrooms" due to their shape. Over time, these dry out, harden, and collapse. Hardened mushrooms transmit motor hum directly to the music. Replace them with fresh, supple rubber reproductions.

Locate the bottom plate of the main bearing housing underneath the chassis.