Always verify the voltage requirements of your load before powering the module. If your motor runs on 12V, you must use a 12V input supply on the VIN pins. 3. Operational Modes & Interface Navigation
To enter the system menu, press and hold the rotary encoder for 2-3 seconds until the screen changes.
Whether you lost your original factory manual or just purchased this airsoft gun second-hand, this comprehensive manual guide covers everything you need to know about operating, maintaining, and troubleshooting your ZK-PP2K. 1. Technical Specifications Zk-pp2k Manual
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
================================================================= BUTTON PWM MODE FUNCTION PULSE MODE FUNCTION ================================================================= FREQ+ Increase frequency Increase Positive Pulse Width FREQ- Decrease frequency Decrease Positive Pulse Width DUTY+ Increase duty cycle Increase Negative Pulse Width DUTY- Decrease duty cycle Decrease Negative Pulse Width ON Toggle output (ON/OFF) Toggle / Interrupt sequence SET Hold 6s to switch modes Hold 2s for Delay/Count settings ================================================================= Step-by-Step Programming Blueprints 1. Programming PWM Mode (Continuous Output) Always verify the voltage requirements of your load
The main IC (located under the board or on the bottom) gets hot above 3A.
In the modern era of workforce management, biometric time clocks have become indispensable tools for businesses of all sizes. Among the most popular devices on the market is the , a robust, fingerprint-based time and attendance terminal manufactured by ZKTeco (one of the world’s leading providers of security and workforce management solutions). Operational Modes & Interface Navigation To enter the
Short-press the encoder to cycle through parameters: P1 (Positive width), P2 (Negative width), P3 (Delay), and P4 (Pulse count). Turn the dial to modify each parameter.
Locate the large assembly pin at the rear of the receiver. Push it out from left to right.
This mode delivers a precise number of pulses after a set delay.